Mobility Robustness Optimization (MRO) encompasses the automated optimization of parameters affecting active mode and idle mode handovers to ensure good end-user quality and performance, while considering possible competing interactions with other SON features such as, automatic neighbor relation and load balancing.
There is also some potential for interaction with Cell Outage Compensation and Energy Savings as these could also potentially adjust the handover boundaries in a way that conflicts with MRO. While the goal of MRO is the same regardless of radio technology namely, the optimization of end-user performance and system capacity, the specific algorithms and parameters vary with technology.
The objective of MRO is to dynamically improve the network performance of HO (Handovers) in order to provide improved end-user experience as well as increased network capacity. This is done by automatically adapting cell parameters to adjust handover boundaries based on feedback of performance indicators. Typically, the objective is to eliminate Radio Link Failures and reduce unnecessary handovers. Automation of MRO minimizes human intervention in the network management and optimization tasks.
The scope of mobility robustness optimization as described here assumes a well-designed network with overlapping RF coverage of neighboring sites. The optimization of handover parameters by system operators typically involves either focused drive-testing, detailed system log collection and postprocessing, or a combination of these manual and intensive tasks. Incorrect HO parameter settings can negatively affect user experience and waste network resources by causing HO ping-pongs, HO failures and Radio Link Failures (RLF). While HO failures that do not lead to RLFs are often recoverable and invisible to the user, RLFs caused by incorrect HO parameter settings have a combined impact on user experience and network resources. Therefore, the main objective of mobility robustness optimization should be the reduction of the number of HO-related radio link failures. Additionally, sub-optimal configuration of HO parameters may lead to degradation of service performance, even if it does not result in RLFs. One example is the incorrect setting of HO hysteresis, which may results in ping-pongs or excessively delayed handovers to a target cell. Therefore, the secondary objective of MRO is the reduction of the inefficient use of network resources due to unnecessary or missed handovers.
Most problems associated with HO failures or sub-optimal system performance can ultimately be categorized, as either too-early or too-late triggering of the handover, provided that the required fundamental network RF coverage exists. Thus, poor HO-related performance can generally be categorized by the following events:
* Intra-RAT late HO triggering
* Intra-RAT early HO triggering
* Intra-RAT HO to an incorrect cell
* Inter-RAT too late HO
* Inter RAT unnecessary HO
Up to Release 9, a UE is required to send RLF report only in case of successful RRC re-establishment after a connection failure. Release 10 allows support for RLF reports to be sent even when the RRC reestablishment does not succeed. The UE is required to report additional information to assist the eNB in determining if the problem is coverage related (no strong neighbors) or handover problems (too early, too late or wrong cell). Furthermore, Release 10 allows for precise detection of too early / wrong cell HO.
Tidak ada komentar:
Posting Komentar